Bobcat E50 W4320 Error Code
W4320 Error Code
"Manbasket mode : Remote control not connected to Manbasket harness (from Receiver CAN Bus signal)" is the main cause of W4320 error.The condenser converts gases into liquids, which expels heat from your rig. Materials can build up over time, causing a layer of dirt and grime to form on the condenser's coils. Your AC system will only blow hot air since the refrigerant fails to cool down.
Tip For E50 Model
Visually check the lifting eye, the clevis and
the lifting chain (lifting device) for any
damage. Replace any damage components
before lifting.
Always use chains or other types of lifting
devices that are intended for this type of use
and that are of adequate strength for the
object being lifted.